The Hub

I have dented the finish in the soundboard of one of my current builds while trying to clean up glue squeeze out after clamping on the bridge. I used a long piece of binding and I guess I held it at a bad angle and there you go. This is only my third guitar build and have steamed out countless dents already in unfinished wood, but I am unsure what to do to get out this dent in the finish other than sand it back at the dent and rebuild f…

I don’t know how many of you make your own binding and purfling, but the MacRostie Binding Trimmer from Stewmac is super helpful in a number of ways. 1. Allows you to make a lot of binding and purfling and have it all sized the same within a few thousandths. 2. I use vulcanized fiber and cut the strips using a utility knife which leaves a kind of burr on edge. Running the laminated fiber/wood or just fiber strips through the trimmer remov…

Hey guys, Trying my first bound headstocks and need some advice on how to approach it once I get to my nut area. I usually shape the headstock with a template and leave about 1/8” before the nut untouched so don’t roll the shape I to the nut slot area(aka a bad time). How do you all approach this process and specifically the nut slot area. I’ve attached some photos so you can see what I mean. Veneer on headstock is about 2mm. Neck is lig…

This guitar will have a piano black finish on most of it and translucent black over the red fabric areas. The client also wants the white binding to be aged. I will be sealing and grain filling with a polyester sealer. My thinking is to tint the first coal of sealer to age the binding , then seal over it with clear. Then tape off binding while spraying color coats. Anyone got an easier way? Suggestions?

Where Does everyone source their binding from? I really would like to cut down on my binding labor, so finding celluloid binding and purfling long enough to wrap around Dread bodies is ideal!!