The Hub

This is a rehash of the amazing Loothprint that Mike (@member@member@member) shared to the group (Surface Inspection Light – The Looth Group). I don't have a 3D printer so had to take a low(er) tech approach. The pics should be self explanatory. I have linked to a DXF and CRV (Vectric VCarve) file in case it helps. I do most simple tooling in Aspire as I can move more quickly there than in Fusion. Components needed: .75" Baltic birch ply Flash…

Hey everyone, I just had a Tele clone built by a small builder in my Proper's Guitar Workstation for a new nut and a fret level. It was clamped down in the workstation for less than a day. I just noticed that the rear hold down clamp left its footprint in the finish. No, I don't know what type of finish the builder used, but I'm trying to find out. I'm thinking its not nitro or poly because I use my TVPGW everyday and this has never hap…

I had to pull some frets on a neck I built to straighten it out 😣 given that the neck is bound, cleaning up the slots with the little StewMac fret saw with the red handle was a serious chore I’d like to avoid doing ever again. I’ve heard the little Japanese fret saw Stew Mac sells is nice to have but also I’ve always been shy about putting a Dremel on the board to get the job done and I think I’d like to try that out. Curious about othe…

I have a few acoustic steel string backs to reglue. Looking for jig ideas to assist in lining up the rib structure for this operation.