The Hub

Hey everyone, I just had a Tele clone built by a small builder in my Proper's Guitar Workstation for a new nut and a fret level. It was clamped down in the workstation for less than a day. I just noticed that the rear hold down clamp left its footprint in the finish. No, I don't know what type of finish the builder used, but I'm trying to find out. I'm thinking its not nitro or poly because I use my TVPGW everyday and this has never hap…

Not sure if this is the best place for this, but whatever. I need somebody to check my logic here--I could be completely wrong in my thinking. I'm about to start up my new shop in Ireland, and the humidity/temperature situation is VERY different than the Greater Washington DC region. I will also be unlikely to have as complete control over temperature and humidity as I did in our extremely tight, air-conditioned house in the US. I also k…

I made a press along the lines of what was described in a John Calkin article in the Ken Parker issue of the American Litherie magazine. Today was my first chance to give it a shot and it seems to have done a great job. I diverged from the article by using Nylok nuts, which ended up being a total pain, definitely not worth The Certainty of it Staying Put. I also added 3D printed feet, so the threaded rod ends wouldn’t scar every surface…