The Hub

Like many of us, I work in a small space - a quarter basement with maybe 6 -1/2 feet of headroom. Sawdust is a problem. There’s no room for an extensive ductwork system or a blower setup. My shop tools (bandsaw, drill press, vertical belt sander, etc.) have a 1-1/2 inch connection for vacuum, but I have mostly been too lazy to use them. (note that I finally added a portable shop air cleaner with HEPA filters). When the most recent Wo…

I just opened a repair shop and the first repair was to remove a broken 1/8" hex wrench ball end from the truss rod nut of a Turner RB4 Renaissance Bass. I read of all sorts of theories on how to extract/remove. None of them had recorded actual attempts of the theories. There's probably others on here but I haven't found them. The ball end was loose and mangled at the rear of the nut sleeve. I tried fairly benign methods first. Heat…

I recently realized its probably time to retire my cheap set of jobber drill bits (Robert Oven standard issue) that are almost a decade old at this point. Does anyone have a set they like or a brand they would recommend?