The Hub

Dovetail was 9/16” deep, and 1 9/16” wide at the back. 15th fret was 1 mm tail side of the end of the dovetail socket but a slight angulation towards the headstock landed in the right place. Hide glue, released easily. Nice everyday player, finish and binding beautiful, good spruce top, warped poplar neck.

I have an old epiphone archtop on my bench that I am struggling to get the neck off of. I think it's a 50's Zephyr (non cutaway, single NY pickup in neck position). Anyone have any experience with these? Is the neck not a dovetail joint? I'm no stranger to neck resets but this is putting up a fight as if it's been epoxied in place.

I'm not sure this belongs in this subcategory, but not sure where else to post it. Could use another set of eyes and expertise on this. Customer came through yesterday wanting to sell a 1950 Gibson L-48. It's been played and loved quite a bit, but despite that it plays and sounds very well. The tuners are cheap replacements, the fingerboard being well worn, and the missing finish in areas, otherwise it seems like everything is structura…

Hallo, I have an old archtop (plywood) that needed a refret. There is no trussrod. I talked to the owner, he knows that my work will maybe/eventually more expensive than the value of the guitar. But it was only after leveling the fretboard that I realized that the fret slots are completely off. I talked to the customer again, and we agreed, that I should put a new fretboard on the guitar. I have one, that I took of an old guitar, and reuse…