The Hub

So, I made a modular clamp based on the split clamp idea. Started on a prototype about two months ago and finished it. What I was aiming for was a clamp that I could use on the BOTTOM of acoustic guitars as well as tops to clamp cracks, cleats, braces, patches etc. Especially a clamp that would access small openings like "F" holes, small sound holes etc. Essentially a way to get a clamp to areas not accessible to jacks, wedges etc.,…

I bought the O'brien vacuum clamp and a pump to clamp bridges on new builds, but also to use for repair work. I got tired of making custom top and bottom cauls for every odd-shaped bridge that comes in my shop. The vacuum clamp works great on a flat surface with no pick guard. I put it on a J45 with a pick guard, and it won't seal. The gasket is too hard to form over the pick guard. I've seen YouTube videos of other folks using vacu…

Please can I see some quick cauls for dealing with fret pressing at heel transitions? For pressed / glued in frets or clamping down lifting fret ends in this area. I’ve tried a few different methods now and not entirely happy with any of them

Today I have spent the better part of five hours attempting to get the fingerboard extension free on this guitar. I am using the method I have used for dozens of neck resets: 100 watt halogen bulb with heat shields. After a couple hours I thought I was making some progress under one corner, only to discover after some movement that my palette knife was going through the top. I then abandoned that area and have been applying heat and…

I've got this Telecaster pickup (1969). The pickup works. Is it possible to flatten the top without gluing it down to the windings? Clamping lightly with a caul slotted for the magnets seats it nicely but I'm not sure how to make it stay there. Any experience with this? Suggestions?

Just realized that I posted this on the main feed earlier and should have posted it here. Apologies for my poor posting skills. Will go and delete the original now.... Hello all, I’m new around here and excited to continue lurking and learning, taking in all the great content and the knowledge of all you experienced looths. I am more familiar with building than repairing, but I am interested in learning all I can about both. I’m happy to…

I'm working on a repair to a Washburn EA50 headstock. Someone previously tried to repair this with a dowel, which likely worked until it was strung up. I've routed a slot and created a biscuit, and built a jig to hold both parts of the headstock in the same plane and clamp everything tight (some cauls and threaded blocks of maple with 1/4-20 machine screws). The plan is to use System 3 gel epoxy (a'la Beau Hannum) and then add a coup…