The Hub

Dear looth community/colleagues around the world, During 2023/24 I have developed a digital gauge to measure so-called longitudinal twist of (bass) guitar necks: the LTwist® gauge. Just to be clear, this is about the "cork screw" type of deviation along the length of a neck, not the bow of a neck. I think there is no need to explain how a too severe neck twist can make it difficult or even impossible to set up a stringed instrument (guita…

If you're like me, you've acquired lots of small luthier tools over the years from StewMac and other vendors. Having a place to store them has always been a problem for me. I stopped drinking soft drinks years ago because they're bad and I recently found out I'm diabetic so they're definitely off the menu. I swapped out soft drinks for water and Crystal Light a long time ago. In our throw away culture, single use plastics are a huge pro…

Are any you using an ultra sonic cleaner to clean metal hardware? If you are, what brand/model are you using and do you find it useful?

This is a rehash of the amazing Loothprint that Mike (@member@member@member) shared to the group (Surface Inspection Light – The Looth Group). I don't have a 3D printer so had to take a low(er) tech approach. The pics should be self explanatory. I have linked to a DXF and CRV (Vectric VCarve) file in case it helps. I do most simple tooling in Aspire as I can move more quickly there than in Fusion. Components needed: .75" Baltic birch ply Flash…

Hey everyone, I just had a Tele clone built by a small builder in my Proper's Guitar Workstation for a new nut and a fret level. It was clamped down in the workstation for less than a day. I just noticed that the rear hold down clamp left its footprint in the finish. No, I don't know what type of finish the builder used, but I'm trying to find out. I'm thinking its not nitro or poly because I use my TVPGW everyday and this has never hap…

I had to pull some frets on a neck I built to straighten it out 😣 given that the neck is bound, cleaning up the slots with the little StewMac fret saw with the red handle was a serious chore I’d like to avoid doing ever again. I’ve heard the little Japanese fret saw Stew Mac sells is nice to have but also I’ve always been shy about putting a Dremel on the board to get the job done and I think I’d like to try that out. Curious about othe…