The Hub

I've been documenting progress of an acoustic kit build from Amazon over on Instagram, would love for some feedback from those that know more than I do. My goal is to build only with the materials provided in the kit, though I'm definitely using as many tools as I have at my disposal. I'm not expecting a quality instrument at the end of it, but I at least want it well built :) Looking forward to any feedback I can get. Thanks. https://ww…

Dear looth community/colleagues around the world, During 2023/24 I have developed a digital gauge to measure so-called longitudinal twist of (bass) guitar necks: the LTwist® gauge. Just to be clear, this is about the "cork screw" type of deviation along the length of a neck, not the bow of a neck. I think there is no need to explain how a too severe neck twist can make it difficult or even impossible to set up a stringed instrument (guita…

Hey folks, I put together a video showing how I measure the long, cross, and transverse frequencies on guitar top plates before thicknessing, following the Gore method. I also walk through using the calculator I built (based on Trevor Gore’s equations) to get target thickness and track density / young's modulus. Fair warning: the video’s a bit YouTube-y in tone thumbnail faces, a little energy for the algorithm, but the content is genuine…

Sorry for the multiple posts (limited by the photo count). Love to hear any general feedback

Being new here, thought I would post an introduction. My name is Paul McGill Mcgillguitars.com I have been making guitars since 1976. I have lived and worked in Nashville since 1985 when I relocated here to work in the repair/restoration shop at Gruhn guitars. 410 Broadway, now a novelty shop. I was there a short time before commiting full time to guitar making as I had done prior to moving here. My main influence as a guitar maker was Ro…

I drew up and printed these F hole plugs for a customer a little while back, felt like showing them off here. The bottom diamond shaped piece has a M4 nut in it, and is super glued to the body of the plug at its two tips. An M4 screw threads into the nut through the counter-sunk hole in the top of the plug. The entire plug drops into the F hole, and then you can tighten the screw slightly to expand the plug so it clamps itself into plac…

Hi everyone. I just wanted to share a new (free!) tool I made, a website for designing fretboards. https://fretboard.buzz. It's similar to FretFind2D, but modernized, with many more features, including fretboard markers, a 'flip' for converting any design to lefty, support for mixed units of measure (use both metric and imperial at the same time), etc. I spent months building it, I would love to get your feedback. Thanks!