The Hub

Few more prints up for grabs to anyone in the US who responds first. Fret sander and two screw holders with the gridfinity lobbed off so they are just free-standing.

Santa heard I had a challenging year so he got me a 3d printer for Christmas. I’ve been printing like crazy, learning the machine. This has resulted in a bunch of tools that either don’t work for me, were attempts at mixing colors, or have very minor printing blemishes. Two lots up for grabs to anyone in the US who wants either. I’ll mail to you for free. First one to claim each gets it :) First lot has parametric nut and saddle sanders…

Here are some pictures that show the basic elements of a dome sander I made. Critical part is a lawn mower blade bearing/spindle. Cost $63. It is marked part # 607418 Blade spindle assembly. It has a tap for a .625-11 bolt on the side I put facing upward to bolt on the disk, and a shaft with a keyway on the bottom to attach to the big pulley. I used a 11” diameter and 2.5” diameter pulley combination. This gives just about the perf…

Like many of us, I work in a small space - a quarter basement with maybe 6 -1/2 feet of headroom. Sawdust is a problem. There’s no room for an extensive ductwork system or a blower setup. My shop tools (bandsaw, drill press, vertical belt sander, etc.) have a 1-1/2 inch connection for vacuum, but I have mostly been too lazy to use them. (note that I finally added a portable shop air cleaner with HEPA filters). When the most recent Wo…