The Hub

Hi guys, it's my first post here. First of all, english is not my first language, so I'm sorry for any mistake or its a bit rough. Recently I have a Sterling Maj200xsm from a costumer that has tunning issues with the tremolo. Any of you has experience with this model? I made a full set up and I checked the nut, saddles, springs, and dont found the trouble. Sometimes there are no issues at all, then the 2º and 3º string goes higher, then…

Hi all, I'd like to get some input on how to address this top blowout. For starters I own this, I got it as a project guitar, 71 D28. I'm not as experienced with acoustics as electrics and this is a big project but I got it to learn new skills and I'm confident I can do it with guidance. It had been stored in the case for many years under tension and was way too humidified. The bridge had pulled up I assume in stages. The center seam se…

It’s Factory Friday! I’ll be in the shop today from 2–4 PM Eastern for the weekly open office hours. Drop in, hang out, ask questions, talk tools, guitar building, SMF, or whatever you’re working on in your shop. No agenda. No presentation. Just shop time. Join at www.stringsmicrofactory.com/factoryfriday See you this afternoon! ✌️

Dear looth community/colleagues around the world, During 2023/24 I have developed a digital gauge to measure so-called longitudinal twist of (bass) guitar necks: the LTwist® gauge. Just to be clear, this is about the "cork screw" type of deviation along the length of a neck, not the bow of a neck. I think there is no need to explain how a too severe neck twist can make it difficult or even impossible to set up a stringed instrument (guita…

If you're like me, you've acquired lots of small luthier tools over the years from StewMac and other vendors. Having a place to store them has always been a problem for me. I stopped drinking soft drinks years ago because they're bad and I recently found out I'm diabetic so they're definitely off the menu. I swapped out soft drinks for water and Crystal Light a long time ago. In our throw away culture, single use plastics are a huge pro…

Are any you using an ultra sonic cleaner to clean metal hardware? If you are, what brand/model are you using and do you find it useful?

This is a rehash of the amazing Loothprint that Mike (@member@member@member) shared to the group (Surface Inspection Light – The Looth Group). I don't have a 3D printer so had to take a low(er) tech approach. The pics should be self explanatory. I have linked to a DXF and CRV (Vectric VCarve) file in case it helps. I do most simple tooling in Aspire as I can move more quickly there than in Fusion. Components needed: .75" Baltic birch ply Flash…

Hey everyone, I just had a Tele clone built by a small builder in my Proper's Guitar Workstation for a new nut and a fret level. It was clamped down in the workstation for less than a day. I just noticed that the rear hold down clamp left its footprint in the finish. No, I don't know what type of finish the builder used, but I'm trying to find out. I'm thinking its not nitro or poly because I use my TVPGW everyday and this has never hap…

I had to pull some frets on a neck I built to straighten it out 😣 given that the neck is bound, cleaning up the slots with the little StewMac fret saw with the red handle was a serious chore I’d like to avoid doing ever again. I’ve heard the little Japanese fret saw Stew Mac sells is nice to have but also I’ve always been shy about putting a Dremel on the board to get the job done and I think I’d like to try that out. Curious about othe…

I have a few acoustic steel string backs to reglue. Looking for jig ideas to assist in lining up the rib structure for this operation.