I need some suggestions from the many great repair senseis out there.The customer is fine with a structural repair and not concerned about making it invisible. I told him you will see anything I do. He was fine with that and has a budget of between $700-1000. It's a clean break. nothing missing, It closes tightly.. I was thinking either 1) the generic double splines one on either side of truss rod and touchup as best I can. Or 2) the ab…
With a break like this with plenty of surface area, I would just glue it without any additional supports. My glue of choice is hot hide glue, but there will be lots of opinions on that and many option…
Hey,
I'm working on a 2017-ish Taylor GS Mini which has a delaminating headstock...see photos...
I was surprised to see that the laminate was plastic...
I reckon quite a few of the community will have done this job many times, so I'm after group wisdom :). Just a small request I know...
Just Fyi...I haven't quoted the customer yet, but I reckon (with some other work I'm doing on the instrument)...our budget will be limited.…
PPP7 replies
7 replies
LikeShare
PPrivate member
Well, a lot of times I just think we replaced the entire neck in the factory because we couldn't make them look right. Unless it was just a small corner of the crown and not lifting anywhere near the…
Let me start with this; I'm trying to find the root cause of difficult fret wire installation of two different SM fret wires. I've spent a lot of time gathering dimensions and experimenting with techniques wich could cause the problem. I enlisted the help of a colleague who arrived at a similar poor performance. His solution was to glue the fret ends/ beat the frets in. My "rather" is to find the root cause so I don't have to go thr…
Matching the fretwire to the fret slots (and visa-versa) is a huge subject. Dan and I did an entire episode of the Dan and Doug Show just on fret slots. I'll be revisiting the subject of fretwork in…
I have repaired numerous top crack on this instrument built by a customer at a guitar building camp. The bridge was off and warped. That has been addressed. After gluing with hide glue and splining the crack these top two did not closed as much as I would have liked. The bigger is about 1/32 at the widest and the other about 1/64. The crack is tight at the bottom. If I can help it I would like to fill it rather than spline it as I have…
I am pretty good at touch up on darker to med woods and air brushing some solid color touchups on electrics but as you said spruce tops with gloss are near impossible. I was hoping to maybe clean it…
Hello, Apologies if this has been answered before, I couldn’t find any posts covering it. I’m looking to get started with an airbrush for small finish repairs. AI is telling me to get a Fengda 186 with 3L tank and a Harder & Steenbeck brush (not cheap!). But would appreciate recommendations for a budget setup from actual human people also. Thanks!
most cheap ones will do you fine, what medium are you using? Nitro? 2k? Water based? 1k? you probably don't need to view more expensive options unless you're looking to get into detailed work. Iwata…
Hello Friends,
I've had a vintage Epiphone acoustic stored at the shop for almost two years and it's about time to wrap it up. That never happens, LOL.
It has a few loose braces, which is a repair I've done in the past. The problem with this one is that no matter how I jack up the loose braces from the inside, some parts of some braces simply do not move enough to come in contact with the soundboard. This is happening in a couple…
