The Hub

Hello, I hope everyone is having a great 4th of July weekend so far. I was recently asked by a friend to work on a cheap S101 bass someone had given to him. It had no electronics and it was severally back bowed. After finishing up the electronics, I did the set up. He wanted the guitar tuned low, to Drop C. So, I went out and bought some Ernie Ball Power Slinkies 55-110. Once I got to the nut depth check, it was clear there were large, g…

I found a cheap double bass in pieces on Facebook Marketbook, so why not try to bring it back to life? Note, I can't play, so look over the awful hacking during the sound clip 🤣

Hi everyone - I recently ran into trouble making new nut for one of my necks that needed to be trued and re-fretted. I roughed in the nut as usual and then, with the bass guitar fully assembled and strung up, I started cutting the slots to depth. I use the StewMac digital nut slot depth gauge and have had good results in the past. I marked the nut's lowest points (radiused) using the guitar nut scribe tool (first time using this!) and c…