The Hub

As seen in the picture. I gotta get this build done in one week and realized I didn’t have black plastic side dots so I whipped some up out of ebony dowel stock. For some reason a yellow stain comes out after I spray with lacquer. I sanded back one time already and respirated but here we are once again. What’s going on here?

I'm working on a repair to a Washburn EA50 headstock. Someone previously tried to repair this with a dowel, which likely worked until it was strung up. I've routed a slot and created a biscuit, and built a jig to hold both parts of the headstock in the same plane and clamp everything tight (some cauls and threaded blocks of maple with 1/4-20 machine screws). The plan is to use System 3 gel epoxy (a'la Beau Hannum) and then add a coup…

I’ve come across several Takamine lawsuit guitars needing neck resets. These lawsuit guitars are from the 1980’s and are basically a copy of a Martin. Pictured below is a 12-string Takamine that came in for a neck reset. After several hours using heat rods at the 15th fret all of the the wooden dowels would not release. My solution was to take a putty knife with a sharpened edge and using a hammer slice the dowels at the joint. As you c…