The Hub

Hey everyone. I’m trying to figure out a wiring scheme for a modded National Triolian resonator guitar. It has a Fishman Resophonic end pin jack pickup (link to that is below) as well as a lipstick pickup that was installed along with a three way switch, and two potentiometers. Essentially what I’d like to do is wire it so there is one volume control for the lipstick pickup, one volume for the piezo, and the three way switch controls eac…

hello looths - i'm building my first guitar. generally following (and enjoying) the gore/gilet books. after 3 tries, i've yet to get a crack free bend around the nose of a venetian cutaway with a mahogany side. i made a version of the fox bender - using clamps on hand for the waist and cutaway, and a pid temp controller (verified accuracy), and am using a stew mac blanket and three straps. the recipe for my last attempt was: sapelle (fo…

This thing had a conveniently placed hole in the neck pickup cavity that ran all the way to the end of the tenon, presumably the entry point for the long drill bit that drilled the access from pickup cavity to control cavity before the neck was originally fitted. I injected several pipettes of hot water into this hole while heating the fretboard extension area with a silicone blanket to loosen the extension from the body. Reactivated hi…

I'll start by saying I don't post much because it's confusing to know if I should post on this site or the Patreon site, both are hard to navigate, etc. Also, I sent this question to the last "elder" meeting but I have no idea what the outcome was (I thought there would be some answers documented for those that can't attend live). So, with those frustrations out of the way... I have in my backlog a 1988 PRS Studio. It has HSS pickup c…

I have two guitars I am working on that are missing a few parts and wanted to see if anyone has them that they would like to sell. I have a customer with an early 50's L5 that he got when he was 10 years old. He wants to reinstall the dearmond rhythm chief but is missing the long beam that connects the controls to the pickup and the small bracket affixes between the string run between the tail piece/bridge. Second, I have a 1978 telecaste…

Being new here, thought I would post an introduction. My name is Paul McGill Mcgillguitars.com I have been making guitars since 1976. I have lived and worked in Nashville since 1985 when I relocated here to work in the repair/restoration shop at Gruhn guitars. 410 Broadway, now a novelty shop. I was there a short time before commiting full time to guitar making as I had done prior to moving here. My main influence as a guitar maker was Ro…

Howdy gang! I was recently trying to find something in my shop and came across a box of 500k linear taper pots. I always use audio taper for volume, but what do you guys and gals think of audio versus linear taper for tone control? I've seen both used, but it's been a bit since I wired a guitar from scratch and can't remember which I prefer. Thoughts?

So, nothing against Luminlay which is an amazing component, with a top notch quality level, but they're quite expensive for what they are. I was messing with ideas and formulas over the past couple weeks, and I think I reached a nice level of quality. On the left my own 'luminlay', on the right the genuine one. Still need to manage how to control the bubble formation but I can finally see the finish line.

I've built some acoustic guitars and I want to get into some electric builds. On that note, I have a highly regarded player around here asking if I could wire an existing solid body to his liking. He is providing two 500K pots, two P90 pickups and a 3 position switch. He wants two volume controls, no tone control. He's quite an accomplished player and I don't know enough to question him. I got a Seymour Duncan diagram from their si…