The Hub

I working through a long top crack repair on a c.1964 Fender Newporter and need to do a little touch-up on the clear coat. The top coat is matte over a do-do brown stained mahogany top, I'm guessing around a 10-20% reflectivity. Questions: 1. What top coat product did Fender use on these? 2. What should I use that has great self-leveling qualities and will melt into the old finish? <>

This is an LP copy from Memphis guitars. It looks like it has had the headstock repaired at some point. Also, there is what looks like some separation of the fretboard near the nut. I don't know if its left over from the repair or if its something new and just trying to go this way. I'm asking the group to look at the pics to help me figure out if any corrective steps are needed. Also from a finish repair standpoint, how to deal with i…

Here You'll seehere pin tip sized bubbles. Nitro finish. It got hot in a case. They'll need a light amagolmater mixture applied to melt'm back into the surface. Im looking for advice on the recipe for said amagolmater....Straight retarder? Im not sure if Id need lacquer in the mix that I apply....Thank you! Colin O'Brien LittleCreek Instrument Repair, Nashville. Images

Hello again folks, how is everyone! So I'm curious about what people here think about re-tops, who's done them, and what sorta ballpark rates you've charged for past completed jobs. I've got a bit of a wild one here, so strap in if you've got a couple minutes for story time! Back in 2012, I traded an HD28V of mine for a cool 1966 D-35 that needed some work. Basically, the body and neck of the guitar were fine apart from…

Greetings fellow Looths! I recently received a request from a customer to replicate Kurt Cobains 59 Martin, starting with a Sigma DM3. I have pasted the customers email to me below. While I have been a looth hobbyist for many years, I just recently opened my official business, Finger Lakes Guitar Works, and am just getting off the ground and a good flow of repair work is already coming in. While I feel 100% confident in my abilities to…

Good morning to all - I have another skill building question - picked up another cheapo electric guitar to practice repairs on. I didn't see the big dent, but figured its an opportunity to practice another type of repair. big chunks of polyurethane finish are gone and the bit that's left has a hairline crack around the bottom. I'm thinking to use wood filler to fill in the missing chunks, and want to know if its best to remove the piec…

Doug Proper designed a sanding jig that supports variable concave and convex curves, described in the following Loothgroup article: https://loothgroup.com/post-imgcap/the-variable-radius-sander/ I built one and am impressed with how it facilitates preparing bridges, braces and also allows tracing any radius using the chord formula. I made a rough measured drawing and assembly guide to share, with Doug's blessing. First step, ma…

I finished levelling frets on a mandolin last week, and was surprised that the frets with the worst divots worked down to .020" Had I known that I'd go that low, I might have replaced them, but it's hard to measure divot height, especially those caused by thin strings. I haven't seen much discussion on standards for fret height or guidelines to know at what point should I switch from levelling to replacement. What standards are peop…

I have repaired numerous top crack on this instrument built by a customer at a guitar building camp. The bridge was off and warped. That has been addressed. After gluing with hide glue and splining the crack these top two did not closed as much as I would have liked. The bigger is about 1/32 at the widest and the other about 1/64. The crack is tight at the bottom. If I can help it I would like to fill it rather than spline it as I have…

I'm replacing the top on an old Stella with white painted "binding." Wondering what kind of paint I should use to come close to the original and be stable under finish. Images