Hi All, I wanted to check in with folks in the industry and ask for some advice. I have been on a building Hiatus for a number of years now (Hand Injury, Medical Issues). Things have gotten much better, and I am fully able and capable of building once again. The 2nd biggest hurdle I have had was a lack of opportunity for shop spaces to build. I now have a viable workspace and full use of my hands once again to build. The problem is that, o…
Hi Peter and buona fortuna on your re-start. I would look into a thickness sander, drill press and small bandsaw. And dust collection! A good router that you can also mount on a router table. A laminat…
I am retopping a guitar and while it's open I want to reduce the mass of the back braces. Since the sides are in the way, I can't figure out how to cleanly cut the excess brace wood away; anything I've tried involves the handle hitting the sides and preventing a controlled, clean cut. Is there a tool - say a "pull finger plane" - that I can pull from the edge to the middle of each brace to facilitate this?
My problem in this parlor guitar is that any chisel I currently have is too long and I can’t address the middle third of the brace without coming in at such an angle that I can’t control the chisel pr…
Dave Slimmer OldSchoolGuitarLoothprintRepair and RestorationLite
