The Hub

Gah! I need help wiring Lollar Monoliths to coil split each pup at their own 2 way mini switch...client brought it in wired to a card ( based on rough drawing ) said he "tested it"....I had to clean up his wiring and soldering some...both pots, 3-way and 2-way switches are functioning but I get a weak signal when plugged in....what am I missing here? I redrew it ( nicer drawing ) with the black hots going to the 3-way ( swapped with gre…

Hello all, A customer dropped a recent American Professional II Strat to have a Double-tap humbucker installed at the bridge. I rewired the guitar following Fender's schematic (see below) and installed a stacked 250 and 500k volume pot, treble bleed PCBs and push-push coil split/tap for this pickup. All went very well, until I tried it at switch position 2. Sure enough, the new unit does not play well with the others and combining delive…

I had a customer that wanted a blower switch installed on his James Tyler HSS style Strat. Simple enough, except that he wanted the full humbucker to go through the volume pot as well. The HB was a 4 wire and incorporated a toggle switch to split coils. I scratched my head for a while, drew up a diagram and breadboarded it. It requires a 6PDT switch which was the hardest part of this job to find something that fits. When the switch…

I recently did a rebuild on a Strat where I went with 2 pickups and a 3 way switch. Goal mess to have an independent volume for each pickup and a master tone. I also added a coil split for the bridge. I went pickups direct to volume pots, pots to the blade switch, and out of the switch to the tone, then to the jack. Issue is the volumes are not fully independent. When in the middle position if I cut the volume to either pickup it acts a…

I've done the Fender Grease Bucket Circuit mod on a lot of Strats and it always works. A customer recently brought in a 335 kit for wiring. It got 3-TV Jones humbuckers, each wired to a Seymour Duncan Triple Shot Mounting Ring, 3 separate volume controls and a master tone with the Grease Bucket circuit. My client wanted to see a clear diagram of the wiring, so I got GuitarElectronics.com to generate one. I've used them several times in…