The Hub

Hi There, I've seen a number of jigs, Some seem like they might work with specific size frets but we all know that even same sized frets have some variances depending batch and where on the line it came off the spool. No matter how i do it I seem to scrape the bottom of the fret trying to make it perfectly flush. I've considered using small rotary round burr or cylinder and only touching the tang so if it does go to deep its…

Hey everyone, I could use some advice as far as the fretting process is concerned. I’ve been doing guitar repair since around 2008, I opened my business doing guitar repair in September of 2021, and I’ve always felt that fretwork has been the most challenging part of this job. I’m getting to the point now where I finally feel like I’m getting the hang of it, but I’m not where I want to be yet. I should mention that I use the Erlewine…