The Hub

There is a pocket in a block below the soundboard that a mortise fits into. It has glue on the sides and bottom that looks like epoxy. This took me four hours to removed

I've seen the Elevate Luthierie jig, and it seems simple enough. One thing I don't like about their explanation video is the handwaving around "set the joint length where you want it"...feels like even with the jig, you have to do too much measuring to make it fit exactly (or within the tolerance you want) Given I can model well enough in Fusion and have a 3D printer, feels like a challenge to take on! As far as I can see, the jig is just…

This thing had a conveniently placed hole in the neck pickup cavity that ran all the way to the end of the tenon, presumably the entry point for the long drill bit that drilled the access from pickup cavity to control cavity before the neck was originally fitted. I injected several pipettes of hot water into this hole while heating the fretboard extension area with a silicone blanket to loosen the extension from the body. Reactivated hi…

Hey Everyone- I have a Martin 000c-16 that is in bad need of a neck reset- Anyone have any experience with this particular model? It’s a mortise and tenon. Will I have more luck using steam or foam cutters? Anything to watch out for? UPDATE-So I think i’m good now. I found a in-depth write up on this model M&T reset process in the new Martin Repair Guide - by Patrick DiBurro Great book BTW- Thanks!

Happy New year everyone!!! I have an LMII neck angle jig but only have the dove tail templates. Would like to try a bolt on for my next acoustic build. With LMII's unfortunate departure do you know where I can get the templates for the mortise and tenon? Is anyone making these? perhaps our friends fortunate enough to have a CNC? I tried making one for a ukelele build but with the tools I have, not confident in the accuracy. Any leads are…