I've seen mention that mandolins can be held in the PWS, but haven't seen any good examples of how to go about it here or in the Total Vice materials. Having just started using one, I'm having a hard time coming up with an acceptable solution on my own. Any experienced advice will be appreciated!
Hi Neil, Mandolins, ukes, banjos and other small instruments work in the Proper's Guitar Workstation just as easily as guitars do. Sadly, Jeff is not very sophisticated digitally on his website or els…
Dave Slimmer OldSchoolGuitarLoothprintRepair and RestorationLite
I took a basic Gridfinity tray and added a bar to the bottom to work with a cheap camera clamping from Amazon. The clamp fits on the main bar of the workstation, allowing an adjustable tool/parts tray to be mounted on the side of the workstation.
This is a simple riser to fit between tuning machines on a headstock. I made two versions. One with a magnetic base and one that just clips on to the workstation.
Just starting to research these items, so forgive the noob question/s… Can these two items be combined? I.e. could one fasten the Erlewine neck jig to the Proper workstation? Or are they two completely different items? Does the Proper workstation allow you to do fretwork under string tension, or is that only on the Erlewine jig? Or could you possibly buy both items, then switch them out on the same mounted post? My primary issue I’d like…
PP7 replies
7 replies
LikeShare
PPrivate member
I do have not the real “Erlewine Neck jig” but a wooden one I cheaply made after the Dan’s ones on the Stewmac books and videos. Quite basic, it was meant to be a first trial to test everything… but i…
donnercruzLoothprintTools, Spaces, Robots, and WidgetsLite
I installed my new Proper’s Guitar Workstation, and other work holding equipment from Total Vise, in my shop this week. I customized my pedestal with a work tray & tool holder, using their “Pedestal Work Board Support." This will keep me from having to always go back & forth to my bench to set things down and get the tools I need, etc. I'm looking forward to how all of this new gear will help make my work easier, quicker, and cleaner, a…
Hey everyone, I just had a Tele clone built by a small builder in my Proper's Guitar Workstation for a new nut and a fret level. It was clamped down in the workstation for less than a day. I just noticed that the rear hold down clamp left its footprint in the finish. No, I don't know what type of finish the builder used, but I'm trying to find out. I'm thinking its not nitro or poly because I use my TVPGW everyday and this has never hap…
PP3 replies
3 replies
LikeShare
PPrivate member
Thanks Doug. I probably should have worded things differently. My goal wasn't to appear to throw shade unnecessarily at the workstation or question its efficacy. I was wondering if the urethane could…
I am a relatively new ”looth”…an amateur/hobbyist at this point, but have recently retired and plan to do much more in retirement. One thing that I am needing at this point is to equip my shop with some better vises and other work-holding equipment. So far I have just used a parrot vise, which has been okay (but not great) for the work I have done so far. I was about to invest in StewMac’s classic Guitar Repair Vise, but one thing I’m r…
Hi Robert, I'll try to offer as much advise as I can. I'm a little biased as you can imagine but I'll try to do my best to be impartial. I don't know based on your question whether you do more building…
5 replies
