The Hub

This guitar does not have a dovetail. It has five dowel. Three in line and two at the top on either side of the truss rod. Remove truss rod nut before sliding neck straight out.

Good afternoon all. I have started the process of removing all the binding from the old Country Gentleman and it's going well. I did discover after removing the strings that the neck is pretty loose and moves around quite a bit (no surprises there). I removed the black plug on the back side of the body then removed the large regular (slot) screw that holds the neck in place. I thought the neck would just slide out considering how loose…

Great Tool. Great Benchy. Testing Threads, Sliding Dovetails, Overhangs, and it’s actually useful instead of that boat.. so testing wear resistance too. igus iglidur I151 Thanks for the model @member

Hello, I am building a bass VI for a customer. As with a Fender Bass VI he wants a control plate with 4 slide switches. 1 on/off switch for each of the 3 pickups, but with the 4the switch he wants to control the phase of the middle pickup. Any suggestions as how I should wire that? thanks!

Hey all, I am really enjoying digging through the looth group. I have not yet watched all the ding kings vids or read all the amazing comments and articles here, but I've been appreciating some of the loothing for dollars stuff, seeing other people's intake sheets, discussions about dealing with customers, and it led me to this question: How do people deal with customer expectations, liability, and the inevitable accidents that can happ…

Hi everyone. I've built a bunch of pickups, in a variety of configurations, but I haven't built a set of blade humbuckers yet. I usually make my own bobbins/flatwork, but since this is my first set of blades, I went ahead and purchased some bobbins to see what they're all about. Which leads me to my question: how does the bobbin retain the blade? With the parts I have, the blade just slides into the top of the bobbin. Not especially snu…

I have an epiphone 335 style guitar on the bench right now. Bad fret buzz on the first frets. No relief in the neck. Pretty Clear its a trussrod adjustment and out the door it goes. But the truss rod is stripped out pretty bad. My 4mm allen fits, in but it has a lot of wiggle. My 5/32" allen doesnt slide in all the way. I dont have a full set of torx wrenches. But i thought that might get some grip. What is the best way to get this thin…

Hello -- I am trying to joint a Tele-style mahogany neck blank. I have a Metabo planer in good condition, but no jointer. I secured the c. 40 mm thick blank to a flat plywood sled and shimmed it well. It's hot-glued in place, and absolutely no rocking from any corner or edge. But as I plane it down, I still have about 1 mm difference from one end of the blank to the other when I put a straightedge on the surface (see photo, with backlig…