Hi All, I wanted to check in with folks in the industry and ask for some advice. I have been on a building Hiatus for a number of years now (Hand Injury, Medical Issues). Things have gotten much better, and I am fully able and capable of building once again. The 2nd biggest hurdle I have had was a lack of opportunity for shop spaces to build. I now have a viable workspace and full use of my hands once again to build. The problem is that, o…
Hi Peter and buona fortuna on your re-start. I would look into a thickness sander, drill press and small bandsaw. And dust collection! A good router that you can also mount on a router table. A laminat…
I am a retired dentist. One saying we had was, “You can’t fix what you can’t see.” And another was, “The day you start working with magnification will be the best and worst day of your practice.” The worst because you will see what you have been missing, and the best because you will never miss it again. So even though I have my Dan E. Model visor loupes, and my retired dental loupes on throughout the day, sometimes, it’s not enough. I pi…
P.S. - I used it this morning to assess how complete my epoxy pore filling was. There was no guessing - I could see the evidence. You could also use your iPhone to magnify - I think on mine the magnifi…
I am retopping a guitar and while it's open I want to reduce the mass of the back braces. Since the sides are in the way, I can't figure out how to cleanly cut the excess brace wood away; anything I've tried involves the handle hitting the sides and preventing a controlled, clean cut. Is there a tool - say a "pull finger plane" - that I can pull from the edge to the middle of each brace to facilitate this?
My problem in this parlor guitar is that any chisel I currently have is too long and I can’t address the middle third of the brace without coming in at such an angle that I can’t control the chisel pr…
Dave Slimmer OldSchoolGuitarLoothprintRepair and RestorationLite
