The Hub

Hey folks! I picked up a neck relief gauge from Doug in one of the earlier batches, maybe the introductory run? Some of the small feet caps that thread onto the moving legs of the tool have cracked, broken, or become worn down. I contacted StewMac about purchasing replacement parts, but they don't sell subparts for the relief gauge and otherwise won't help me. They appear 3D printed, so I was wondering if anyone with the means to print s…

I've built a number of classical guitars with an adjustable neck and they seem to gather quite a bit of interest, so i'm currently in the process of looking to refine the design and build. It's quite a simple construction where the neck is held together by string tension and hangs on a pivot. I developed a 3d printed "socket" which acts as the interface between the body and the guitar and allows for some fine tuning of the alignment of t…

Hey Everyone! I have finally gotten jealous enough of everyones 3d printing antics and want to get in on it. Does anyone have a suggestion for starter setup. I have saved around $500. Should I hold off and save more? I do not have any big goals but would like to copy some of the looth prints. Thanks!

I had a Flashforge Adventurer 5m pro and liked it but it suddenly stopped connecting to WiFi. Customer support was super frustrating and I returned it. But i did like it when it worked, aside from wishing it had a larger print bed. Any recommendations on what I should look at in the <$400 range? I’ve been reading and googling but have yet to find any advice that seems to hit the spot. Thank you!

I had a feeling I should have updated Fusion before 3D Club... Todays New update introduced Project Isoparametric Curves "Isoparametric curves in the Sketch environment, adding new ways to extract surface U and V curves for more controlled lofts, rails, and surface transitions" ...The meridians on the shaft surface seen in the attached photo. I still haven't fully grasped how to align these between faces, attached is a quick…