The Hub

Here You'll seehere pin tip sized bubbles. Nitro finish. It got hot in a case. They'll need a light amagolmater mixture applied to melt'm back into the surface. Im looking for advice on the recipe for said amagolmater....Straight retarder? Im not sure if Id need lacquer in the mix that I apply....Thank you! Colin O'Brien LittleCreek Instrument Repair, Nashville. Images

I did a pretty big update to my web tools last week. These are updated from the older versions I had up on celestialinstruments.com. There’s an updated FFT tool now, plus mode detection for guitars and plates, wolf note detection, played-note energy transfer, monopole mobility, plate thickness calculation, and 1/2/3/4 DOF modeling that can be prefilled from FFT data. The part I’m most excited about is being able to fit a measured guitar re…

Hi folks, I thought you might be interested in this approach to having easy height adjustment for a GoBar deck. I learned this tip from my buddy, Don Parker. He lurks around here too from time to time. :) The basic idea is rather than having a booster platform on the base for use when gluing braces to plates you bring the roof down lower. There is a 3D printed spacer in black in the pics. I linked to a downloadable STL and 3MF of…

I'm building my first BRW guitar, started with the back, pictured below. What do you normally thickness BRW sides to? I guess they can probably be a bit under 2 mm, but I don't want to overdo it in case there is some slight deformation that needs to be sanded later. I bend manually on a heating iron if that makes any difference.