Hey everyone, I was showing this to James Roadman on the Loothalong, and I thought I’d share it here with anyone who might find it helpful. I was installing an Anthem in a GS Mini, and I couldn’t get the microphone to fit without hitting the ballends of the strings. I had thought about placing the mic on the other side of the pins, but then I decided to use a scalpel and a small file to cut some chamfers into the corners of the mic housi…
A Gagliano Jumbo probably made by Kay in the 1950's. It looks like this had a previous neck reset based on the shims and some sloppy chisel work. I removed the 14th and 15th frets because I had read that these might have a straight tenon. I didn't need to drill any holes for heat, as the spruce shims both split in half after the fretboard extension was released. The dovetail is about 11mm long, the pocket is 14mm deep, and the 15th fret…
P1 reply
1 reply
LikeShare
PPrivate member
So it's a traditional dovetail joint then? Hard to tell if there is a taper from photos. The Galiano-labeled guitars made by the Italian luthiers working in NYC in the first half of the 20th century…
This is a Kamouraska classical guitar, model 111, made in Canada in 1979. Internet information says it was made in La Patrie, Quebec, and later the line became La Patrie guitars. It looks like someone has been into this one before as the dovetail fit was poor, the gluing is very sloppy, and there are some rough chisel marks on the face of the heel. Note that if you drilled holes at the 13th fret you would miss the pocket by a few mm. Th…
