The Hub

Just posted a full build video for the last mandolin batch over on YouTube. Give it a watch folks, its 25 mins long. And there should be a few woodworking tips there for some of you, and some lovely tunes all played on my work.

Hi all. Brand new member. I’ve been building a classical guitar via kit from LMI for a couple of years now. I keep putting it off but recently became motivated to get back to it. Unfortunately LMI is out of business so I now have no one to go to to ask questions. I’m at the stage where I’m putting the sides together in the form. I followed the dimensions for the form based on the plans as I measured them, but the sides overlap pretty ba…

So, I've stained the body and neck and I'm in the process of applying several (3 or 4) coats of epoxy to them for pore filling. I watched Michaels video on the subject. My question is: When sanding the epoxy I beleive I should stay above the wood (stay in the epoxy) since it is stained, right??? When doing this same process on a body and neck that is not stained, I could sand back to the wood without consequence if I'm consistent…

Hi there folks! Many months ago I watched a video (or probably a live streaming) with Doug Proper -among others- in which there was a part where he talked about necks weak point in the heel area and other stuff such as neck relief terminology. That topic keep buzzing me in the head, is possible to have a proper (small) discussion about that? I have a couple question

A while back I saw a Canna Guitars video on Instagram and thought his use of the “wave” scarf joint between his neck and headstock was an interesting use of CNC. But it got me thinking about other options, and this idea percolated in my brain: Cut a regular scarf joint, but then using a CNC cut a tenon into the neck, and a mortise/dado into the headstock. (Obviously you could also do this by hand with a saw and chisel). The joint would i…

In Michael Baskin's on-line video, he uses a frequency test of a guitar in the white to determine whether to thin the lower bout before finishing. The guitar in the video has a bridge attached. I'm wondering if this is the final bridge or something temporary. If the latter, how do the results compare to the final frequency analysis? I've used a bolt-on bridge to do the same, but don't have enough data points to draw a firm conclusion…

Hey folks, I put together a video showing how I measure the long, cross, and transverse frequencies on guitar top plates before thicknessing, following the Gore method. I also walk through using the calculator I built (based on Trevor Gore’s equations) to get target thickness and track density / young's modulus. Fair warning: the video’s a bit YouTube-y in tone thumbnail faces, a little energy for the algorithm, but the content is genuine…

Heres a link to a youtube video I just quickly put up unedited of my latest build!

[ The majority of my learning has come from the Blues Creek Guitars YouTube videos and reading books (i.e. no mentor/formal training). ] When I checked the centerline (picture with ruler is pre-adjustment), I was slightly off the perpendicular. So I removed a tiny amount from the cheek (side with the purple tape), getting that nice and flush and centerline where I want it. But now I have a .035" gap on the other side. What should I check…

There are two new sub forums in New Builds and Repair and Restoration called “share your content”. Got a new youtube video ? Share it there. Got a new Instagram Reel ? Share it there. Did you just cut a killer new miter and just want to share it ? Share it there. Anything you want to share that doesn’t involve a question, share it there. Speaking of which, I should probably share this there.

This was a lot of fun! Check out my friend Alberto Ziliotto, he is a great musician! Enjoy... I did :)