The Hub

Hey folks! I picked up a neck relief gauge from Doug in one of the earlier batches, maybe the introductory run? Some of the small feet caps that thread onto the moving legs of the tool have cracked, broken, or become worn down. I contacted StewMac about purchasing replacement parts, but they don't sell subparts for the relief gauge and otherwise won't help me. They appear 3D printed, so I was wondering if anyone with the means to print s…

Great Tool. Great Benchy. Testing Threads, Sliding Dovetails, Overhangs, and it’s actually useful instead of that boat.. so testing wear resistance too. igus iglidur I151 Thanks for the model @member

https://forums.autodesk.com/t5/fusion-design-validate-document/need-lofting-advice-or-is-there-a-better-way-for-this/m-p/13219436

I drew up and printed these F hole plugs for a customer a little while back, felt like showing them off here. The bottom diamond shaped piece has a M4 nut in it, and is super glued to the body of the plug at its two tips. An M4 screw threads into the nut through the counter-sunk hole in the top of the plug. The entire plug drops into the F hole, and then you can tighten the screw slightly to expand the plug so it clamps itself into plac…

I made a press along the lines of what was described in a John Calkin article in the Ken Parker issue of the American Litherie magazine. Today was my first chance to give it a shot and it seems to have done a great job. I diverged from the article by using Nylok nuts, which ended up being a total pain, definitely not worth The Certainty of it Staying Put. I also added 3D printed feet, so the threaded rod ends wouldn’t scar every surface…