Hi All, I wanted to check in with folks in the industry and ask for some advice. I have been on a building Hiatus for a number of years now (Hand Injury, Medical Issues). Things have gotten much better, and I am fully able and capable of building once again. The 2nd biggest hurdle I have had was a lack of opportunity for shop spaces to build. I now have a viable workspace and full use of my hands once again to build. The problem is that, o…
Hi Peter and buona fortuna on your re-start. I would look into a thickness sander, drill press and small bandsaw. And dust collection! A good router that you can also mount on a router table. A laminat…
I am retopping a guitar and while it's open I want to reduce the mass of the back braces. Since the sides are in the way, I can't figure out how to cleanly cut the excess brace wood away; anything I've tried involves the handle hitting the sides and preventing a controlled, clean cut. Is there a tool - say a "pull finger plane" - that I can pull from the edge to the middle of each brace to facilitate this?
My problem in this parlor guitar is that any chisel I currently have is too long and I can’t address the middle third of the brace without coming in at such an angle that I can’t control the chisel pr…
Doug Proper designed a sanding jig that supports variable concave and convex curves, described in the following Loothgroup article:
https://loothgroup.com/post-imgcap/the-variable-radius-sander/
I built one and am impressed with how it facilitates preparing bridges, braces and also allows tracing any radius using the chord formula. I made a rough measured drawing and assembly guide to share, with Doug's blessing.
First step, ma…
Just wanted to say I bought a chisel through Hyperkitten Tool Company and it went great. It's very old school, ordering and shipping are not a fast process, but if Josh has a tool that piques your interest I highly recommend it. I picked up this long boi paring chisel from the mid to late 1800s and I'm quite happy. https://hyperkitten.com/
Hi everyone, I am getting closer to finalising the specs for the first production run of the Untangler Pro. The Untangler Pro is made of stainless steel, and it is designed to clean up the underside of fret?s overhangs after clipping away the tang. It works with a Dremel or similar tool and a cutting wheel. The order for the parts needed for the first run will most likely go out next week, so if you want one, now is the time. You can mess…
