The Hub

Got my new printer a few weeks ago, and I have been loving life in 3D. I have made a bunch of cauls and tools in preparation for my next builds. On all the prints the first layers were a little fuzzy, so I did some research and adjusted the z offset. Got my first layers in the pocket. But that caused some horrible problems. Now I can’t even finish a print. First layer is fine. Second layer is hairy and fuzzy. Seems like the nozzle is dr…

Didnt know what Section to put this in but I thought it may fit the best here. I would like to get my air brush Set up to start some finish repairs. I was wondering those of you in limited space and just use an air brush what your setups looked like. I have limited extraction points and cant just do it outside. are the model painter desk top extractors enough for small touch up? pictures would be ace. Andy

Have you ever had a really stubborn bridge plate to remove? I had one not too long ago that seemed to resist wetting with a damp cloth, and subsequently all the heat I could get from my silicone heating pads. After much effort I got about 80% of it out cleanly. The remaining 20% required hours of work with a finger plane. That experience made me think about the Brown's Guitar Factory bridge plate removal tool I had purchased years ago,…