Hello, I just received an unfinished, slotted but not fretted maple neck from Warmoth. I believe standard practice is to fret then finish but I’m curious if it might be better finish before fretting? I understand one would want to prevent finish from entering the slots. I’m and going to use tru oil and do a light finish, maybe three or four light coats. Thoughts for this beginner? Dave
PP4 replies
4 replies
LikeShare
PPrivate member
My recent favorite neck finish is Boiled Linseed Oil. It gives a nice smooth, but not shiny finish when applied sparingly. As for fretting order, I would do the frets first so any potential damage to…
It was attacked by a Martin Dreadaught on a small mountain stage resulting in a faceplant. The top is Redwood. I was able to get it to glue up fairly well and have done some splice and drop fill on the vertical cracks. I'm curious about suggestions for the deep cross grain areas. I am hoping to not re-shoot any lacquer and just rub out the finish with some Kovax dry sanding. It was never high gloss buff to begin with and it's a personal…
P3 replies
3 replies
LikeShare
PPrivate member
@member Thanks Ian, I also have some ultra thin fill&finish on the way. I will do some experimenting with it and see if it can help me out any.
Hi friends,
I just stumbled upon a 1966 P-Bass, nearly completely original. The owner bought it in 1971 and it had already been stripped of its original finish. That was a thing back then. You can guess that 55 years of gigging had the wood absorb much of the owner’s DNA and sweat. Maybe a few beers as well. Surface was quite tacky as you can expect. I cleaned it with naphta and StewMac’c brand-new cleaner (quite a great product I'd say…
Ill chime in. Go with shellac first. It may be all you need and if you decide to go with something else, youve already applied the universal seal coat. Also, it has the best chance of sticking to any…
Hello, I hope everyone is having a great 4th of July weekend so far. I was recently asked by a friend to work on a cheap S101 bass someone had given to him. It had no electronics and it was severally back bowed. After finishing up the electronics, I did the set up. He wanted the guitar tuned low, to Drop C. So, I went out and bought some Ernie Ball Power Slinkies 55-110. Once I got to the nut depth check, it was clear there were large, g…
PP5 replies
5 replies
LikeShare
PPrivate member
9m✎🗑 A standard heat treatment, with the neck clamped in an upbow, should help. I have been using an Aria neck heat bar for 50 years with more successes than failures. You can find the Aria on eBay for…
Howdy folks, I'm a 2026 graduate of the two year guitar program at Red Wing (Minnesota State College Southeast). Between my two years at Red Wing I worked at Collings Guitars in Austin, TX for two years in the acoustic neck department, shaping and finish sanding ~2000 necks, radiusing and gluing ~750 fingerboards, and pressing ~100 sets of frets. I also spent a couple months in the finishing department level sanding and pore filling ~300…
4 replies
