The Hub

When using epoxy (either silvertip or epoxy), I try to sand back the epoxy on the surface and only leave it in the pores. I'll start the process with sanding to 320g or so then using an air compressor to blow out the pores. The challenge that I run into is opening new pores in the process. I use a block of wood and long strokes in an attempt to avoid uneven sanding. Ultimately I'll get a good pore fill but I tend to apply several coats…

Howdy folks, I'm a 2026 graduate of the two year guitar program at Red Wing (Minnesota State College Southeast). Between my two years at Red Wing I worked at Collings Guitars in Austin, TX for two years in the acoustic neck department, shaping and finish sanding ~2000 necks, radiusing and gluing ~750 fingerboards, and pressing ~100 sets of frets. I also spent a couple months in the finishing department level sanding and pore filling ~300…