The Hub

I'm reading the Design book of the Gilet/Gore set (2nd Edition) and ran across something that surprised me. Under "Top bracing layout - guidelines" (Section 4.4.8, pp 4-52) Gore writes, "Brace ends that are housed into the linings stiffen the edge of the soundbard considerably and so constrain its mobility. Unless you are chasing a particular effect, it is generally not very beneficial to house the lower bout braces into the linings." My…

(Just to set expectations, I bought this for the sole purpose of learning. Not a client project) I got this Martin D28-12 in destroyed condition, after an airline did something awful. As I see it: - Top cracks - Back cracks - Top & side separation with some broken off kerfing - Brace ejected When I was looking at the pictures online pre-purchase, I thought I might take the neck off and re-top it, or at the very least, take the top off and fix…

So, I made a modular clamp based on the split clamp idea. Started on a prototype about two months ago and finished it. What I was aiming for was a clamp that I could use on the BOTTOM of acoustic guitars as well as tops to clamp cracks, cleats, braces, patches etc. Especially a clamp that would access small openings like "F" holes, small sound holes etc. Essentially a way to get a clamp to areas not accessible to jacks, wedges etc.,…