The Hub

Greetings Wise Elders and fellow seekers of the Looth Group! I hope you're all keeping well. I humbly beseech thee for thine sage wisdom and experience. I purchased a 1971 Hagstrom Swede. This guitar was basically put in a case and then forgotten about for a few decades. I felt sorry for the old man and have taken it in as a stray / project. I would like to get it playing again. There are many scars on this guitar, I have looked for as…

Hi all, new to nut slot work world, please can you help me with this mystery? fret levelling, neck relief and string action adjustment all completed to Fender 9.5" radius spec. very happy with that. the next step: 0.011” High E string’s nut slot was a bit low. I used Dave Johnson’s (MI Guitar Craft Academy) “q-tip slot raising method”: the pulled cotton strand, plus extra thin CA glue, to fill the slot, then trim it off once dry,…

Hi, Any recommendations for scratch safe and nitro safe bench coverings? Also the porous sanding mats compatible with vacuum tables with same nitro safe properties? My material science education is low in regards to stuff that will and won't react to nitro. Thank you.

Found this, will print later, saves a little design time. https://makerworld.com/models/1835300?appSharePlatform=copy Having made 3D printed Vacuum fixtures for CNC previously, I’d recommend printing as close to 100% theoretical density as possible, as any voids can and likely will lead to suction loss. Finer dimensional stability and layer adhesion with something with Glass Fibres will probably help. I’d avoid materials with additives th…