The Hub

Have you ever had a really stubborn bridge plate to remove? I had one not too long ago that seemed to resist wetting with a damp cloth, and subsequently all the heat I could get from my silicone heating pads. After much effort I got about 80% of it out cleanly. The remaining 20% required hours of work with a finger plane. That experience made me think about the Brown's Guitar Factory bridge plate removal tool I had purchased years ago,…

Any electronic wizards know how this switch would be wired for a simple volume / tone circuit for two single coil pups? I cannot find a good answer using the internet search so far. A diagram for dummies would be amazing.

Hey everyone, Well I had a bit of a day today. The issue is a paint chip out on a matte finish 3 month old Ibanez RG 421. I was in the middle of a pup install and was backing out the screw holding the 5 way switch. As you can see from the pics there must have been some paint sitting above the screw and well viola! I thought it best to try to glue the chips back in but I used accelerator (BSI) because well I’m a dumb ass and it looks like…