The Hub

good evening to all. This one showed up on the marketplace. I'm wondering if its too much to chew for me at this time. Is it a very difficult repair? Is it worthwhile pursuing? It's another $25 crash test dummy. Please, don't hold back. I can take it.

Hi all, I am a newer guitar tech and after dozens of repairs this particular Simon & Patrick Luthier Cedar top SP6 acoustic dreadnought from the 90-ies with a bolt-on maple neck has been an incredible challenge. It came with a maxed out and stuck truss rod with a considerable up bow in the neck, extremely low saddle with barely any string break angle, so it needed a neck reset. Later on I figured out that it also has a pretty dras…

Hello again folks, how is everyone! So I'm curious about what people here think about re-tops, who's done them, and what sorta ballpark rates you've charged for past completed jobs. I've got a bit of a wild one here, so strap in if you've got a couple minutes for story time! Back in 2012, I traded an HD28V of mine for a cool 1966 D-35 that needed some work. Basically, the body and neck of the guitar were fine apart from…

Greetings, I was wondering if anyone has expierence with good a supplier for red spruce, preferably old growth, that they would point me to. This would be for acoustic tops/sound boards. From the reading I've done, it seems that the "Adirondack" variety might be the prized piece to get. Haven't decided if torrified is what I'm looking for. I'm also going to need to get brace wood of the same species. Any and all suggestions are…

Has anyone removed the stabilizer bar from a Fender Wildwood Acoustic guitar? I need to repair the bridge area and I cannot figure out how to remove the internal stabilizer bar. Any input would be appreciated

The COE reviewed this bridge disaster in January, a Tanglewood acoustic given to me that had the bridge ripped off as well as some of the underlying top, and an attempted repair with spruce veneer (COE video link https://www.youtube.com/watch?v=AlpOIWQrAlw&t=2685s). The general opinion was to install a bigger bridge plate. However, once I removed the existing bridge plate, I found that the underlying repair had not been fully done,…

Hello Friends, I've had a vintage Epiphone acoustic stored at the shop for almost two years and it's about time to wrap it up. That never happens, LOL. It has a few loose braces, which is a repair I've done in the past. The problem with this one is that no matter how I jack up the loose braces from the inside, some parts of some braces simply do not move enough to come in contact with the soundboard. This is happening in a couple…