The Hub

Hey all, I have been working with the work station for a few months now. I love it. I found a few little things that have helped me. 1. A mic stand to support the main beam. I bought the Total Vise version and it didn't work as well. 2. Rockler Bench Cookies as rear cross member supports. They have the correct 5/16-18 inserts in them and screw on easily. Now the thread rod has a sort of hi/low setting by just flipping it for acoustic or…

Where is everyone getting their shim stock from? Looking to buy blanks in bulk - mainly for electric neck pockets. Thanks!

Have an electric archtop that has a .012" backbow strung with 12-48s with truss rod completely loosened. 3 piece maple neck with a Ziricote fingerboard... Any tips or recommendations to straighten this neck would be appreciated... Currently trying humidity (in the case). Thank you! David O'

Since most of us fix or make guitars, we have probably heard something about the cease and desist letters Fender has sent out concerning the Stratocaster. I thought I would offer some thoughts. As always, caveat emptor. There are three basic ways to protect intellectual property under Federal law. Patent, trademark, and copyright. Each protects different things, and has different underlying legal theories. Lets begin with pate…

Hi Folks Newbie here so please bear with me. I have a lovely early 90's Yamaha LD-10E acoustic in for repair, I think all solid wood? made in Indonesia and a lovely sounding instrument, however the electrics are letting it down. The pre-amp has a PCB populated with SMD electrolytic caps. Many of these have leaked and destroyed the PCB pads underneath. Repairing the traces is nigh on impossible so it looks like I'll have to replace t…

Hello — I would like to finish a mahogany electric neck and body with wipe on poly (probably Minwax satin) and would like to pore fill with Z-Poxy. I can’t find a definitive word on their compatibility. - Can I just wipe on the poly coats after block sanding the 2-3 Z-Poxy coats? - Should the Z-Poxy be sanded all the way back to wood or just smoothed/flattened? - Is a coat of unwaxed shellac between the Z-Poxy and the wipe in…

Hi all, new to nut slot work world, please can you help me with this mystery? fret levelling, neck relief and string action adjustment all completed to Fender 9.5" radius spec. very happy with that. the next step: 0.011” High E string’s nut slot was a bit low. I used Dave Johnson’s (MI Guitar Craft Academy) “q-tip slot raising method”: the pulled cotton strand, plus extra thin CA glue, to fill the slot, then trim it off once dry,…