The Hub

When using epoxy (either silvertip or epoxy), I try to sand back the epoxy on the surface and only leave it in the pores. I'll start the process with sanding to 320g or so then using an air compressor to blow out the pores. The challenge that I run into is opening new pores in the process. I use a block of wood and long strokes in an attempt to avoid uneven sanding. Ultimately I'll get a good pore fill but I tend to apply several coats…

Hello — I would like to finish a mahogany electric neck and body with wipe on poly (probably Minwax satin) and would like to pore fill with Z-Poxy. I can’t find a definitive word on their compatibility. - Can I just wipe on the poly coats after block sanding the 2-3 Z-Poxy coats? - Should the Z-Poxy be sanded all the way back to wood or just smoothed/flattened? - Is a coat of unwaxed shellac between the Z-Poxy and the wipe in…

So, I've stained the body and neck and I'm in the process of applying several (3 or 4) coats of epoxy to them for pore filling. I watched Michaels video on the subject. My question is: When sanding the epoxy I beleive I should stay above the wood (stay in the epoxy) since it is stained, right??? When doing this same process on a body and neck that is not stained, I could sand back to the wood without consequence if I'm consistent…

I am switching from NC lacquer to EM6000. I also want to switch from black WB filler to blackened epoxy grain fill. My question relates to keeping the color in the pores and off the surface wood, and whether to vinyl seal before and/or after epoxy fill, I already know how to tint epoxy black. Could black grain fill style be accomplished with black epoxy as the grain filler and would a vinyl sealer be used at all, or just use EM6000 for…

Has anyone used the aqua coat pore filler? If so are there any issues I would need to know about. I'm planning to fill natural walnut (no stain). Should I use a sealer first?

I do have a question. I want to pore fill Spanish Cedar. I’m wanting a glass smooth finish. Im finishing with urethane. I usually use a polyester sealer that I spray on ( simtec) but it takes several coats. I have some z Poxy. Can I pore fill with it and then spray sealer? What say you all?