The Hub

Any suggestions if this can be saved? It is a neck I received for free upon replacing it for a customer. The wood was missing and the rod is missing the adjusting nut. The truss rod had pushed the inlay out as well as the wood damage . I wasn't sure if it could be a structurally sound repair. I have no idea of the neck rigidity or action with strings. I wont be online because of a previous dr. appointment but I figured it would be a go…

Hi, I have a 1950's Gibson LG-3 that's had some poor work done to the spruce under the area of the bridge where the spruce has pulled away and or been sanded excessively. It's missing about .020-0.30 thou of spruce and I'm wondering/looking for advice about how to go about splicing in a thin piece of spruce before I re-glue the bridge. Please see pictures attached. My main questions are: glues for the patch, should the patch be mitered…

HEy Folks, Just wondered if anyone had a source for a 4-inlay SJ200 bridge? I have a 52/53' in for restoration, and...well... I like replacements better than making them if I can help it, especially this mustashio'd monster!

I'm refretting an all-original Gibson L-7 from 1934, and it has a 9.5" or so fretboard radius. However, the bridge, also original, has a 12" radius. I need to flatten the board, as it has a hump at the tenth, but I'm wondering if I go with the 9.5" radius, or try and get it to 12". I'm a little worried about sanding through the Nick Lucas style inlays, so I'd like some input here. If I kept the 9.5" radius, I'd likely have to radius the…

1952 Gibson Southern Jumbo. I drilled 2 holes 1 cm from the edge through the 15th fret slot for the wire heaters. This one didn’t require any steam just a lot of boiling water. Be weary of the celluloid inlays and binding. They melt fairly easily. (Oops) It happened to a friend once! lol

I recently picked up a gutted first year Country Gent with a headstock break. It had been previously "repaired" with mystery glue, nails, bondo and believe it or not.....staples. I am likely out of my depth here but I want to bring this little bit of history back to life. I scraped off the bondo and that is when I found the staples hiding underneath. I removed the staples and gave the headstock some gentle pressure and found that the ga…

Hi Gang, I hope someone can help me fix my f**kup. This is a new build. I burned the top trying to steam out a dent preparing for finishing. At least the dent is gone. I started sanding, but it wasn't going away. I looked on the inside and I see a little discoloration, so it goes all the way through. It is just north of the tail block. Is a "decorative Inlay" my only solution? I will await suggestions while I reevaluate my life choice…

I acquired this old single cut JR around 6 years ago. Was aware of the previous breaks and repairs, wasn't a particular concern as I acquired through trade. The headstock broke a couple years ago with a very small sideways tumble ( in its case). I used some clamps and rubber tubing to glue the break back together. Decided to scrape back the finish and see at the previous repairs. I see epoxy, carribbean walnut splines, carbon fiber 1/8…