The Hub

Hey all, I have been working with the work station for a few months now. I love it. I found a few little things that have helped me. 1. A mic stand to support the main beam. I bought the Total Vise version and it didn't work as well. 2. Rockler Bench Cookies as rear cross member supports. They have the correct 5/16-18 inserts in them and screw on easily. Now the thread rod has a sort of hi/low setting by just flipping it for acoustic or…

Greetings Wise Elders and fellow seekers of the Looth Group! I hope you're all keeping well. I humbly beseech thee for thine sage wisdom and experience. I purchased a 1971 Hagstrom Swede. This guitar was basically put in a case and then forgotten about for a few decades. I felt sorry for the old man and have taken it in as a stray / project. I would like to get it playing again. There are many scars on this guitar, I have looked for as…

Guitar fell straight down on the headstock when it was hanging up at the refinishers. Shit really does happen! Grain is pretty much shattered around the adjustment nut. Thinking I’ll replace the entire broken area with a completely new piece of mahogany. Scarf it in between the volute and 3rd fret. Probably even a 3 piece lamination to mimic the neck. This one was not the clients fault so the expectations for looking close to original a…

I've built a number of classical guitars with an adjustable neck and they seem to gather quite a bit of interest, so i'm currently in the process of looking to refine the design and build. It's quite a simple construction where the neck is held together by string tension and hangs on a pivot. I developed a 3d printed "socket" which acts as the interface between the body and the guitar and allows for some fine tuning of the alignment of t…

I've owned this Jersey City made 12-string/drone 'harp' guitar for a few years and want to get on the repair. I've taken the necks off many dozens of Schmidt-made guitars but never one with two necks. I've searched the web looking for harp guitar neck removal and didn't find anything of use. Asking for any tips/aids/experience from the loothers. My plan is to make a custom neck removal jig that fits the necks, and then drill the typical…

Hey guys. I guess this is an old topic, everyone talks about it but I haven't been able to find a definitive solution for this. Here's the deal: I'm working on a PRS Silversky that has this old problem that when you use the trem bar, one string (G in this case) goes sharp. I made a few adjustments to the nut as we all know that's the first thing to look at...no good. This guitar is new so I'm pretty much ruling out the bridge and posts si…