The Hub

Rask Guitars — Utah (relocation required) Rask Guitars is a Utah-based custom shop dedicated to building exceptional instruments — primarily high-end acoustics, alongside electric guitars and prototypes. We operate with a small, focused team where craftsmanship isn't just a standard, it's the entire point. We're growing, and we're looking for a skilled, experienced luthier who's ready to plug into a real production environment, contribute…

Hi Folks Newbie here so please bear with me. I have a lovely early 90's Yamaha LD-10E acoustic in for repair, I think all solid wood? made in Indonesia and a lovely sounding instrument, however the electrics are letting it down. The pre-amp has a PCB populated with SMD electrolytic caps. Many of these have leaked and destroyed the PCB pads underneath. Repairing the traces is nigh on impossible so it looks like I'll have to replace t…

Hello — I would like to finish a mahogany electric neck and body with wipe on poly (probably Minwax satin) and would like to pore fill with Z-Poxy. I can’t find a definitive word on their compatibility. - Can I just wipe on the poly coats after block sanding the 2-3 Z-Poxy coats? - Should the Z-Poxy be sanded all the way back to wood or just smoothed/flattened? - Is a coat of unwaxed shellac between the Z-Poxy and the wipe in…

Good morning to all - I have another skill building question - picked up another cheapo electric guitar to practice repairs on. I didn't see the big dent, but figured its an opportunity to practice another type of repair. big chunks of polyurethane finish are gone and the bit that's left has a hairline crack around the bottom. I'm thinking to use wood filler to fill in the missing chunks, and want to know if its best to remove the piec…

Hi all, new to nut slot work world, please can you help me with this mystery? fret levelling, neck relief and string action adjustment all completed to Fender 9.5" radius spec. very happy with that. the next step: 0.011” High E string’s nut slot was a bit low. I used Dave Johnson’s (MI Guitar Craft Academy) “q-tip slot raising method”: the pulled cotton strand, plus extra thin CA glue, to fill the slot, then trim it off once dry,…

I recently picked up a used custom guitar that the seller said he bought in Vietnam Nam many years ago. I bought it as a wall hanger due to the wonderful Mother of Pearl work, especially on the back. It was very apparent that the top on this instrument was sunken at least 3/8 of an inch, as the weird bridge setup was heightened to the max and there was barely any action height. Once I took it apart and removed the foam inside, I was…