The Hub

Hello, Apologies if this has been answered before, I couldn’t find any posts covering it. I’m looking to get started with an airbrush for small finish repairs. AI is telling me to get a Fengda 186 with 3L tank and a Harder & Steenbeck brush (not cheap!). But would appreciate recommendations for a budget setup from actual human people also. Thanks!

Just joined the group and have only built 3 guitars so far but just ran into trouble on my latest project. Long story short: I built a '57 LP Jr that came out fantastic but the neck was set incorrectly and was nearly unplayable. I cut off the body and made a new one and applied the burst and a few coats of clear before gluing in the salvaged neck. To finish up the neck joint with a bit more black, I dusted off my 20 yo Paasche airbru…

Didnt know what Section to put this in but I thought it may fit the best here. I would like to get my air brush Set up to start some finish repairs. I was wondering those of you in limited space and just use an air brush what your setups looked like. I have limited extraction points and cant just do it outside. are the model painter desk top extractors enough for small touch up? pictures would be ace. Andy