The Hub

I don’t have CNC capabilities so I could not duplicate Dave Slimmer’s version ( https://loothgroup.com/loothprint/bridge-clamping-cauls/). Got a 12x18x1/2 inch HDPE cutting board on Amazon for under $10 (https://www.amazon.com/dp/B001D3LQVA), drilled a row of 1/2 holes about 5/16” deep with a Forstner, cut the HDPE into 5 sided chunks so I could orient by touch, and free handed the brace grooves on the band saw. The clamp swivel pads are 1…

Good morning everyone, I was taking some measurement on production necks with scarf-joint (13° headstock angle) to add some machining process with the cnc. I so recreated the standard neck blank feature (100mm wide and 20mm thick), then drawed the 13° angle. Everything correspond the to the real piace but two measurement: the startingcut behind the break angle is ''off'' by 20mm +/- as well as the cut on the bottom, still off by 20mm…

Rask Guitars — Utah (relocation required) Rask Guitars is a Utah-based custom shop dedicated to building exceptional instruments — primarily high-end acoustics, alongside electric guitars and prototypes. We operate with a small, focused team where craftsmanship isn't just a standard, it's the entire point. We're growing, and we're looking for a skilled, experienced luthier who's ready to plug into a real production environment, contribute…

Good evening folks, lately I'm experiencing some sanding methods/mechanism frustration. Can't explain better than look like I'm regressing at doing it. The only thing changed in my building routine is that I'm currently using a CNC (I haven't used one for some years) for both bodies and necks. I have no problems with necks, but sanding bodies has become incredibly frustrating, specially around the edges. While I keep improving my c…