The Hub

Hi All, I wanted to check in with folks in the industry and ask for some advice. I have been on a building Hiatus for a number of years now (Hand Injury, Medical Issues). Things have gotten much better, and I am fully able and capable of building once again. The 2nd biggest hurdle I have had was a lack of opportunity for shop spaces to build. I now have a viable workspace and full use of my hands once again to build. The problem is that, o…

good evening to all. This one showed up on the marketplace. I'm wondering if its too much to chew for me at this time. Is it a very difficult repair? Is it worthwhile pursuing? It's another $25 crash test dummy. Please, don't hold back. I can take it.

This guitar does not have a dovetail. It has five dowel. Three in line and two at the top on either side of the truss rod. Remove truss rod nut before sliding neck straight out.

Hey Looths, I have a 1980 Guild 12 string in the shop and while doing a preliminary examination I noticed this odd discoloration inside of the guitar. My immediate thought was water damage, although it hasn't bled through to the outside of the guitar and lifted the finish. I also thought of glue smear but I can't quite tell. Any thoughts here?

At what point do you tell a customer that their acoustic instrument needs a bridge reglue? Do you do it when the corners are just barely starting to lift? Once it has begun to affect playability/tuning stability? Do you offer half-measures to save them money when the damage is not too bad (dripping in some thinned tite bond instead of removing the bridge entirely for example)? I ask this because a Godin acoustic bass just came across my…

I've owned this Jersey City made 12-string/drone 'harp' guitar for a few years and want to get on the repair. I've taken the necks off many dozens of Schmidt-made guitars but never one with two necks. I've searched the web looking for harp guitar neck removal and didn't find anything of use. Asking for any tips/aids/experience from the loothers. My plan is to make a custom neck removal jig that fits the necks, and then drill the typical…

LOOTHTOOL I've made some purchases on LOOTHTOOL, but it will not let me review. SO, the VL’s Precision Feeler Gauge Set is a rock solid 10 of 10 or five Amazon stars. Nice blades, EXCELLENT tool box, well marked, I'm thrilled!

Question about splines: At what point are they necessary? My question is primarily regarding the crack to the left between the bridge and the sound hole as well as the crack at the upper bout that runs along the fingerboard extension. I have already glued them both and used the TJ cleats that run the full length of the cracks. I have already splined the lower bout crack that runs from the bridge to the binding as it was super gappy and d…

Hi all, I am a newer guitar tech and after dozens of repairs this particular Simon & Patrick Luthier Cedar top SP6 acoustic dreadnought from the 90-ies with a bolt-on maple neck has been an incredible challenge. It came with a maxed out and stuck truss rod with a considerable up bow in the neck, extremely low saddle with barely any string break angle, so it needed a neck reset. Later on I figured out that it also has a pretty dras…